this time jic female swivel fitting can be re-flared front amputated

 If you use a male and female cone top pressure seal, which is mostly due to the two cone leak damage, is available on the cone grinders for grinding. In some with "о" or outer-ring seal on the end face of the occasion,Hydraulic hose clamps the leakage following reasons: "о" ring deformation caused by aging or leakage; "о" ring assembly is not in place, so that the two-plane connection when the pressure is uneven or "о" ring is cut cause leakage; "о" ring is not compacted,jis flanges less elastic deformation caused by leakage; "о" mouth-ring groove just too deep and cause leaks. In this regard, the need to re-select the same diameter and cross-sectional thick "о" rings can also be sealed with a flat opening slot stop cutting or grinding to reduce the groove depth mouth only to make "о" rings are sufficiently resilient deformation (compression typically be between 0.35-0.65mm). For use oil sheet, wool felt, soft steel board, combination gasket sealant joints or pipe leaks, no matter what the material is, you should first check the seals for damage, deformation, aging and rough through the large, etc. and then take the appropriate measures.