female swivel fitting leak prevention

In the hydraulic system, both the metal pipe fitting, hose fitting, or are prone to leakage problems. For card sets of pipe joints, mostly due to the pipeline by a larger force or impact, so that the card sleeve loose or pipe end surface deformation caused by leaks, you should check whether the jic flare fittings card sets out of round, edge or without defects, whether the pipe ends in good condition and the extent of compression ferrule nut, but also eliminate the pipeline force. For flared fittings, mostly due to excessive flaring, substandard quality requirements or repeatedly demolished, resulting in flaring deformation or cracks caused by the hose adapters leak, this time jic female swivel fitting can be re-flared front amputated. If you use a male and female cone top pressure seal, which is mostly due to the two cone leak damage, is available on the cone grinders for grinding. In some with "о" or outer-ring seal on the end face of the occasion, the leakage following reasons: "о" ring deformation caused by aging or leakage; "о" ring assembly is not in place, so that the two-plane connection when the pressure is uneven or "о" ring is cut cause leakage; "о" ring is not compacted, less elastic deformation caused by leakage; "о" mouth-ring groove just too deep and cause leaks. In this regard, the need to re-select the same diameter and cross-sectional thick "о" rings can also be sealed with a flat opening slot stop cutting or grinding to reduce the groove depth mouth only to make "о" rings are sufficiently resilient deformation (compression typically be between 0.35-0.65mm).